Home › Air Conditioners & Heat Pumps › LG Electronics › Error E1

LG Electronics Air Conditioners & Heat Pumps Error Code E1 - Water Inlet & Filling Failure

Low Severity

Error code E1 on LG Electronics air conditioners & heat pumps indicates a water inlet & filling failure detected by the internal system diagnostics.

Appliance: LG Electronics Air Conditioners & Heat Pumps

Estimated Time: 10-15 minutes

Tools Required: Pliers, bucket, small wire brush

⚠ Common Symptoms & Observations

The LG Electronics air conditioners & heat pumps fails to fill with water; quiet buzzing from rear solenoid valves; cycle pauses after 5-10 minutes.

🔍 Root Causes for Code E1

Water supply shutoff valve closed
kinked cold/hot water inlet hoses
clogged sediment mesh filters at hose connections
faulty inlet solenoid valve
low water pressure.

🔧 Step-by-Step DIY Troubleshooting & Fix Guide

Verify both cold and hot water faucets at the wall are fully open.

Inspect the hoses behind the unit for kinks or crushed sections.

Turn off wall valves, unscrew the hoses from the back of the LG Electronics unit, and use pliers to pull out the small plastic mesh inlet screens. Clean sediment under running water.

Reconnect securely and test fill.

🔄 Master Reset Procedure for LG Electronics

Turn off unit, open and firmly close the door/lid, and press Start.

Technician Tip: If the error code reappears immediately after a hard reset, the control board has detected an active electrical open circuit or failed component that requires physical inspection.